Annealing newbie - Anyone tried this DIY annealer?

Jun 6, 2024 · Very reasonably priced and works great. Reply. Reactions: Treeslug, skipglo, HRM Johnny and 3 others. OutsideBill Well-Known Member ... I made a induction annealer DIY and …

CouponFollow Extension

$200
OFF

Annealing Newbie - Anyone Tried This DIY Annealer?

1 week from now

Dec 12, 2024 · If you can self-build a decent induction annealer for $200, it's surprising that no one has mass manufactured and sold them completed. I, for one, would like to move away …

longrangehunting.com

$200
OFF

Induction Annealing For $200 | Tennessee Hunting & Fishing Forum

1 week from now

Feb 26, 2021 · I just built one of these and it works great. Forums. New posts Search forums. What's new. New posts New Trophy's New trophy room comments. Media. New media New …

tndeer.com

FAQs about Annealing newbie - Anyone tried this DIY annealer? Coupon?

How much does it cost to build an annealer?

Annealing is quick, taking less than $400 and only two items had to be homemade. The total cost was for all parts, which were sourced from hardware stores, Jamesco Electronics, or Amazon. Upwards of 5 seconds per case, for about 10-20 minutes for 100 cases. ...

How long does it take to build an annealer?

It takes about 10-20 minutes for 100 cases, or approximately 5 seconds per case, to build an annealer. The total cost was less than $400, and all parts were sourced from hardware stores, Jamesco Electronics, or Amazon. ...

Does induction heating work with nonferrous metals?

Induction heating actually does work with nonferrous metals but it is just far less efficient. You can work around that inefficiency in this case by increasing the number of turns in your coil and increasing the current driven through it. Why would you think induction would not work? Been used for a long time with different annealers. ...

How much does a templaq annealer cost?

Basically I use 750F templaq to set the wheel speed timer to the flame intensity then adjust the feeder wheel. The whole build cost me about $200 which I think is pretty cheap for an annealer! ...

How long does it take to anneal a single case?

Annealing is quick, taking only 5 seconds per case. The process takes approximately 10-20 minutes for 100 cases. I did not mention that the annealer I built cost less than $400. ...

Why is annealing a single target temperature impossible?

The large variations in times different cases take to heat up using a fixed power output with time control only make one single target temperature impossible to use as an annealing target. AMP stopped doing anything temperature related years ago when they introduced hardness testing as their means of validating their results. ...